Electrolux EI30EW35KW - Manual (Page 7)

30" & 27" Electric Single Wall Ovens
Under-Counter Installation Specifications
• Product Weights – (EW30EW55G and EI30EW35J) 200 Lbs. /
(EW27EW55G and EI27EW35J) 150 Lbs.
• Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit fused
on both sides of line.
• Connected Load (kW Rating) @ 240 / 208 Volts =
(30") 4.0 / 3.0 kW / (27") 3.4 / 2.6 kW
• Amps @ 240 / 208 Volts = (30") 17.0 / 14.5 Amps / (27") 14.2 / 12.6 Amps
• Recommended Circuit Breaker – 20 Amps
• Always consult local and national electric codes.
• Minimum 21" clearance for oven door depth when open.
• Minimum 23-1/2" deep cutout dimension is critical for proper installation,
to ensure that oven’s faceplate will fit flush against cabinet front.
• Full oven base of solid plywood or similar material required, capable
of supporting 200 Lbs. (30" models) or 150 Lbs. (27" models). Install
over two runners and flush with toe plate.
• Base must be level and cabinet front must be square.
• Allow 5" maximum height from oven base to floor, if NO cooktop is
installed directly over wall oven.
Electric Cooktop Installation Over
30" / 27" Electric Single Wall Oven Specifications
Electrolux Single Wall Oven models EW30EW55G, EI30EW35J,
EW27EW55G and EI27EW35J are approved to be used beneath
Electrolux cooktop models EW36EC55G, EW30EC55G, EW36IC60I,
EW30IC60I, EW36CC55G and EW30CC55G.
For detailed Electric or Induction Hybrid Cooktop installation, refer to
model-specific product page and installation guide on web.
• Side filler panels necessary to isolate oven from adjoining cabinets.
Panel height may need to be modified to accommodate the depth of
approved electric cooktop models.
• To route armored cable to junction box, cut minimum 4" x 4" opening
in right cabinet side panel.
• Allow 4-1/2" maximum height from oven base to floor, if cooktop is
installed directly over wall oven.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxappliances.com for detailed instructions.
Electric Cooktop Installation
Over 30"/27" Electric Single Wall Oven
High standards of quality at Electrolux Home Products, Inc. mean
we are constantly working to improve our products. We reserve the right
to change specifications or discontinue models without notice.
Electrolux Major Appliances, N.A.
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-877-4electrolux (1-877-435-3287) • electroluxappliances.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca
EC_EW INST EL 10/10 © 2010 Electrolux Home Products, Inc. Printed in the U.S.A.
Oven cutout
27 1 / 4 " min.
28 1 /
4
" max.
4-1/2" maximum height allowed
from oven base to floor if cooktop
is installed directly over wall oven.
(5" maximum height allowed
with no cooktop.)
240 /208V
Junction box
for wall oven
Approx. 3"
*Critical dimension – MUST be applied
**For cooktop cutout dimensions refer to model-specific
product page or installation guide on web
240 /208V
Junction box
for electric
cooktop
Approx. 3"
36"
min.
Cooktop
cutout**
To route armored cable to junction box through left
cabinet side panel and/or filler panel, cut minimum
4" x 4" opening in wood base and runner
Cutout Width (A)
30" Wall 28 1 /
2
" min.
Oven 29" max.
27" Wall 24 7 / 8 " min.
Oven 25 1 /
4
" max.
For all approved electric cooktop models, cut minimum
4" x 4" opening in right cabinet side panel and/or filler
panel, to route armoured cable to junction box
Electric Single Wall Oven Cutout
For models: EW30EW55G, EI30EW35J,
EW27EW55G & EI27EW35J
24" min.
cutout depth
23 1 /
2
min.*
A
Unit will overlap cutout (minimum) edges by 1"
Install 3 / 4 " full plywood base on 2 runners,
flush with toe plate, capable of supporting
200 lbs. (30" models) and 150 lbs. (27" models)
Side filler panels necessary to isolate oven from
adjoining cabinets. Panel height may need to
be modified to accommodate the depth of approved
electric cooktop models