Electrolux EI30DS55LW - Manual (Page 16)

16
Surface Cooking
PlaceMent of buRneR Heads and caPs
location of tHe buRneRs
Place a burner cap on each burner head, matching the
cap size to the head size. The cap for each burner has
an inner locating ring which centers the cap correctly
on the burner head. Be sure that all the burner caps
and burner heads are correctly placed BEFORE using
your appliance.
Make sure each burner cap is properly aligned and
level.
Turn the burner on to determine if it will light. If the
burner does not light, contact a Service Center. Do
not service the sealed burner yourself.
burner cap
fixed burner
Head
The cooktop is equipped with different sized burners.
The surface burners are located on the cooktop as follows (See
Figure):
- a
5 000 BTU (natural gas) burner located at the right rear
position;
- a 16 000 BTU (natural gas) burner located at the right front
position;
- a 9 500 BTU (natural gas) burner located at the left front position;
- a 14 000 BTU (natural gas) burner located at the left rear
position.
PRoPeR buRneR adjustMents
The color of the flame is the key to proper burner adjustment. A good flame is clear, blue
and hardly visible in a well-lighted room. Each cone of flame should be steady and sharply
defined. Adjust or clean burner if flame is yellow-orange. To clean burner, see instructions
under General Care & Cleaning.