Electrolux EIDW1805KS - Manual (Page 10)

10
Installation Instructions
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or dis-
poser using either previously determined method.
Waste Tee Installation Disposer Installation
IMPORTANT
–
When connecting
drain line to disposer check to be sure that drain
plug has been removed. DISHWASHER WILL NOT
DRAIN IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges.
Always be sure disposer drain plug has been
removed before attaching deishwasher drain hose
to the disposer.
Method 1 - Air gap with waste tee or disposer
Figure W
Waste Tee Installation Disposer Installation
Figure X
STEP 12 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES
The drain hose molded end will fit 5/8", 3/4" or 1"
diameter connections on the air gap, waste tee or
disposer. Cut on the marked line as required for
your installation.
• If a longer drain hose is required, add up to 42"
of length for a total of 10 ft. to the factory in-
stalled hose. Use 5/8" or 7/8" inside diameter
hose and a coupler to connect the two hose
ends. Secure the connection with hose clamps.
• Secure the drain hose to the air gap, waste tee
or disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST
NOT EXCEED 10 FEET FOR PROPTER DRAIN
OPERATION..
Method 2 - High Drain loop with waste tee or disposer