Solutions to common problems, Dishwasher leaks, Normal sounds you will hear – Electrolux EIDW6405HT User Manual
Page 20: Water in the bottom of the tub, Dishwasher won’t run, Dishwasher does not drain properly, Cycle takes a long time, Dishwasher won’t fill
20
Solutions to Common Problems
DISHWASHER LEAKS
•
Use only fresh detergent designed for
automatic dishwashers. Measure detergent
carefully. Try a different brand.
•
Spilled rinse aid can cause foam and lead to
overflowing. Wipe up any spills with a damp
cloth.
•
Check to see that dishwasher is level (See
Installation Instructions).
NORMAL SOUNDS YOU WILL
HEAR
•
Normal sounds include water fill, water
circulation and motor sounds.
•
Pump pulsing will cause motor speed to
increase and decrease at regular intervals
during cycles.
WATER IN THE BOTTOM OF
THE TUB
•
It is not normal for water to remain in the
bottom of the tub at the end of a cycle. If
water remains in the bottom of the tub at the
end of a cycle, the dishwasher may not be
draining properly. (See Dishwasher Does Not
Drain Properly). The filter may also need to
be cleaned. (See Care of Filter, page 16.)
Note: It is normal to see a small amount of
water under the filter at the end of a cycle.
DISHWASHER WON’T RUN
•
Check to see if circuit breaker is tripped or if
a fuse is blown.
•
Make sure water supply is turned on.
•
Check to see if cycle is set correctly.
(See Operating Instructions, pages 5-8.)
•
Check to see if the DELAY START option has
been selected.
•
Make sure door is closed and latched.
DISHWASHER DOES NOT
DRAIN PROPERLY
•
If unit is hooked up to a garbage disposal,
make sure the disposer is empty.
•
If unit is hooked up to a new food waste
disposer, check to see if the “knockout” plug
located inside the disposal inlet has been
removed.
•
Check to see if drain hose is kinked.
•
Make sure cycle is complete, not in a pause.
CYCLE TAKES A LONG TIME
•
Check to see if cycle is in a water heating
delay.
•
Check to see if the delay start option has
been selected.
•
Check to see if the sanitize option has been
selected.
•
Check to see if dishwasher is in the Child
Lock cycle.
•
Make sure Float is down and is not stuck up.
DISHWASHER WON’T FILL
•
Check to see if the water supply is turned on.
•
Add 1/2 cup of water to the bottom of the unit
and start again.
•
Make sure Float is in and down.