ATD Tools ATD 37155 - Manual (Page 2)

2
INSTRUCTION MANUAL FOR WIRE WELDING MACHINES
IMPORTANT:
READ THIS MANUAL CAREFULLY BEFORE
INSTALLING, USING, OR SERVICING THE WELDING
MACHINE, PAYING SPECIAL ATTENTION TO SAFETY
RULES. CONTACT YOUR DISTRIBUTOR IF YOU DO
NOT FULLY UNDERSTAND THESE INSTRUCTIONS.
1 INSTALLATION
This machine must be used for welding only. It must not be
used to defrost pipes.
It is also essential to pay special attention to the chapter
on SAFETY PRECAUTIONS.
The symbols next to certain paragraphs indicate points
requiring extra attention, practical advice or simple infor-
mation.
This manual must be stored carefully in a place familiar to
everyone involved in using the machine. It must be con-
sulted whenever doubts arise and be kept for the entire
life-span of the machine; it will also be used for ordering
replacement parts.
1.1 PLACEMENT
Unpack the machine and place it in an adequately venti-
lated area, dust-free if possible, taking care not to block
the air intake and outlet from the cooling slots.
CAUTION: REDUCED AIR CIRCULATION causes over-
heating and could damage internal parts.
Keep at least 500 mm of free space around the machine.
Never place any filtering device over the air intake points
of this welding machine.
The warranty shall become void if any type of filtering
device is used.
Mount the parts supplied with the machine as shown in
the figure 1.
2 DESCRIPTION OF THE MACHINE
A) Switch
Turns the machine on and off, and also regulates the
welding voltage range.
B) Setting knob
This knob serves to adjust the welding wire speed.
C) Earth cable
D) Yellow LED
Lights only when the thermostat is tripped and
interrupts the machine operation.
E) Green LED
Indicates that the machine is turned on.
F) Welding torch
G) Handle
Must not be used to lift the machine.
3 GENERAL DESCRIPTIONS
3.1 SPECIFICATIONS
This welding machine allows welding of soft steel, stain-
less steel and aluminium.
3.2 EXPLANATION OF TECHNICAL SPECIFICATIONS
Fig. 1
Fig. 2