Adder Technology AdderLink AV Series User Manual
Page 13
12
To connect the power supply
NOTE: Please read and adhere to the electrical safety information given within
the
section of this guide. In particular, do not use an
unearthed power socket or extension cable.
1 Attach the output connector of the power supply to
the socket labelled
POWER
on the AdderLink AV
transmitter.
2 Insert the IEC connector of the power cable
into the corresponding socket of the
power supply.
3 When all other connections
have been made at the
transmitter and receiver
modules, connect the other
end of the power cable to a
nearby earthed mains socket.
TRANSMITTER
ADDERLINK
IN
IN
1 00
TRANSMITTER
200
ADDERLINK
IN
IN
To connect the serial port (AdderLink AV200 only)
Note: The serial port feature supports RS232 serial devices at speeds up to
57600 baud and all hardware handshake lines are available. No extra error
checking on the serial port signals is applied.
1 Attach the male connector of a serial link cable (Adder part
number: CAB-9M/9F-2M) to the socket labelled
on
the AdderLink AV200 transmitter.
2 Attach the other end (female connector) of
the serial cable to the appropriate RS232
serial socket on the source PC
system.