Electrolux EQG4120BOG - Manual (Page 51)

DAILY USE
IGNITION OF THE BURNER
WARNING!
Be very careful when you use open
fire in kitchen environment. Manu-
facturer decline any responsibility in
case misuse of the flame
Always light the burner before you
put cookware.
To light the burner:
1. Turn the control knob counterclock-
wise to the maximum position (
)
and push it down.
2. Keep the control knob pushed for ap-
proximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and its
cap are in correct positions.
A
B
C
A) Burner cap and crown
B) Thermocouple
C) Ignition candle
WARNING!
Do not keep the control knob
pushed for more than 15 seconds.
If the burner does not light after 15
seconds, release the control knob,
turn it into off position and try to
light the burner again after mini-
mum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
gas release position.
If the burner accidentally goes out,
turn the control knob to the off po-
sition and try to light the burner
again after minimum 1 minute.
The spark generator can start auto-
matically when you switch on the
mains, after installation or a power
cut. It is normal.
TURNING THE BURNER OFF
To put the flame out, turn the knob to the
symbol
.
WARNING!
Always turn the flame down or
switch it off before removing the
pans off the burner.
ENGLISH 51