Asus M2NPV-MX - Manual (Page 37)

A S U S M 2 N P V - M X A S U S M 2 N P V - M X A S U S M 2 N P V - M X A S U S M 2 N P V - M X A S U S M 2 N P V - M X 1 - 2 7 1 - 2 7 1 - 2 7 1 - 2 7 1 - 2 7
3 . 3 . 3 . 3 . 3 . I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E )
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cable(s). There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to the
motherboard's IDE connector, then select one of the following modes
to configure your device(s).
M2NPV-MX
®
M2NPV-MX IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1
SEC_IDE
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
Black or gray
D r i v e j u m p e r D r i v e j u m p e r D r i v e j u m p e r D r i v e j u m p e r D r i v e j u m p e r M o d e M o d e M o d e M o d e M o d e C a b l e C a b l e C a b l e C a b l e C a b l e
s e t t i n g s e t t i n g s e t t i n g s e t t i n g s e t t i n g o f d e v i c e ( s ) o f d e v i c e ( s ) o f d e v i c e ( s ) o f d e v i c e ( s ) o f d e v i c e ( s ) c o n n e c t o r c o n n e c t o r c o n n e c t o r c o n n e c t o r c o n n e c t o r
Single device Cable-Select or Master - Black
Two devices Cable-Select Master Black
Slave Gray
Master Master
Slave Slave