2 if you cannot find a solution, Installation, 1 before the installation – Electrolux EHI6740FOK User Manual

Page 15: 2 built-in hobs, 3 connection cable

Advertising
background image

Problem

Possible cause

Remedy

comes on.

There is an error in the hob

because a cookware boils

dry. Automatic Switch Off

and the overheating protec-

tion for the zones operate.

Deactivate the hob. Re-

move the hot cookware. Af-

ter approximately 30 sec-

onds, activate the zone

again. If the cookware was

the problem, the error mes-

sage goes out. Residual

heat indicator can stay on.

Let the cookware become

sufficiently cool. Check if

your cookware is compati-

ble with the hob.

Refer to “Hints and tips”

chapter.

comes on.

The cooling fan is blocked.

Check if objects block the
cooling fan. If

comes

on again, speak to an Au-

thorised Service Centre.

comes on.

The electrical connection is

incorrect. The hob is con-

nected only to one phase.

Speak to a qualified electri-

cian to check the installa-

tion. Refer to the connec-

tion diagram.

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Give also three

digit letter code for the glass ceramic (it is

in the corner of the glass surface) and an

error message that comes on. Make sure,

you operated the hob correctly. If not the

servicing by a service technician or dealer

will not be free of charge, also during the

warranty period. The instructions about

the Service Centre and conditions of

guarantee are in the guarantee booklet.

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the

information bellow from the rating plate.

The rating plate is on the bottom of the

hob.

Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in units

and work surfaces that align to the

standards.

8.3 Connection cable

• The hob is supplied with a connection

cable.

• Replace the damaged mains cable with

a special cable (type H05BB-F Tmax

90°C; or higher). Speak to your local

Service Centre.

ENGLISH

15

Advertising