Bosch HDS7052U - Manual (Page 3)

Safety Instructions
Preparation
Installation
Final Steps
English • 1
... Our Inspiration
Important Safety Instructions
Please read all instructions before using this appliance.
PARTS PROVIDED:
Anti-Tip Bracket
TOOLS AND PARTS NEEDED:
•
Range Power Supply Cord Kit with strain relief
(240V - 30 Amps) *
• Standard Measuring Tape
• Phillips Head Screwdriver
• 1-1/4” Wrench
• Pencil
• T-20 Torx Screwdriver
• 3/8” Nut Driver
• Screws (2) and Anchors (2) for Anti-tip Bracket
(Style will vary depending on mounting surface)
• Pipe Wrench (2)
• Teflon® Tape** or Pipe Joint Compound
(Appropriate for use with LP gas and Natural gas)
• Channel Lock Pliers
• Gas Leak Test Solution
• Level
• Drill and Drill Bit
• Gas Supply Line (Flexible Metal Appliance Connector
or Rigid Pipe)
• Gas Shut Off Valve (If not already present)
• Gloves and Safety Goggles
* Not needed for Canadian installations
** Teflon is a registered trademark of DuPont
Table of Contents
Important Safety Instructions .......................................................................................... 1
Preparation ................................................................................................................... 3
Installation .................................................................................................................... 5
Final Steps ................................................................................................................... 7
• Remove all tape and packaging before using
the range. Destroy the carton and plastic bags
after unpacking the range. Never allow children to
play with packaging material.
• Be sure your appliance is properly installed
and grounded by a qualified technician in
accordance with the National Electrical Code ANSI/
NFPA No. 7 latest edition and local electrical code
requirements.
Important: Local codes vary. Installation, electrical
connections and grounding must comply with all
applicable codes.
• Install only per installation instructions
included in the literature package for this
range.
• Ask your dealer to recommend a qualified
technician and an authorized repair service.
• Know how to disconnect the power to the
range at the circuit breaker or fuse box in and the
gas supply at the shutoff in case of an emergency.
• Do not repair or replace any part of the
appliance unless specifically recommended in
the manuals. All other servicing should be done by
a qualified technician. This may reduce the risk of
personal injury and damage to the range.
• When testing the supply piping system at test
pressures in excess of 1/2 psig (3.5 kPa), the
appliance and its individual shutoff valve must
be disconnected from the gas piping system.
• When testing the supply piping system at test
pressures equal to or less than 1/2 psig (3.5
kPa), the appliance must be isolated from the
gas supply piping system by closing its
individual manual shutoff valve.
• Never modify or alter the construction of a
range by removing leveling legs, panels, wire
covers, anti-tip brackets/screws, or any other part
of the product.
• Do not lift door by door handle. Remove the
door for easier handling and installation. See
Section ‘Removing Oven Door’ in Use and Care
manual.
• Do not store or use combustible materials,
gasoline or other flammable vapors and
liquids in the vicinity of this or any other
appliance.
• WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, authorized service agency or the
gas supplier.
If the information in this manual is not followed
exactly, a fire or explosion may result causing
property damage, personal injury or death.
WARNING