Bosch HCP30E51UC - Manual (Page 7)

7
State of California Proposition 65
Warnings
WARNING
This product contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm.
Causes for damages
CAUTION
Risk of damage due to corrosion. Always turn
appliance on when cooking to avoid condensation
buildup. Condensation can lead to corrosion
damages.
Always replace defective bulbs immediately to avoid an
overload of the remaining bulbs.
Risk of damage due to ingress of humidity into the
electronic circuitry. Never clean operator controls with a
wet cloth.
Surface damage due to incorrect cleaning. Clean
stainless steel surfaces in the grind direction only. Do not
use any stainless steel cleaners for operator controls.
Surface damage due to strong or abrasive cleaning
agents. Never use strong and abrasive cleaning agents.
Risk of damage from condensation back flow. Install
exhaust vent at a slight downward slope away from the
appliance (1° slope).
Protecting the environment
Unpack the appliance and dispose of the packaging in
line with environmental requirements.
Operating modes
You can use this appliance in the air extraction or the
recirculation mode.
Note: This product will not comply with Energy Star
specifications when installed as non-vented
(recirculating) with the optional recirculation kit.
All openings in ceiling and wall where canopy hood will
be installed must be sealed.
Fan operation
Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct used
for ventilating furnace installation areas.
If the ventilation is intended to pass through a smoke
or exhaust that is not in operation, the responsible
area heating inspector must give approval.
If the ventilation passes through an external wall, use a
telescope wall sleeve.
The air that is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
To ensure quiet operation of ENERGY STAR qualified
inline and remote fans, each fan shall be installed using
sound attenuation techniques appropriate for the
installation. For bathroom and general ventilation
applications, at least 8 feet of insulated flexible duct shall
be installed between the exhaust or supply grille(s) and
the fan. For kitchen range hood remote ventilation
applications, where metal duct is generally required by
code, a metal sound attenuator shall be installed between
the range hood and the fan.