Electrolux ESF2300OW - Manual (Page 56)

7.1 Using the detergent
A B
C
D
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.2 Using the combi detergent
tablets
When you use tablets, that contain salt
and rinse aid, do not fill the salt container
and the rinse aid dispenser.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the low-
est position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.
7.3 Setting and starting a
programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• The display shows 2 horizontal status
bars.
• The indicators of the programme but-
tons come on.
If the control panel shows other condi-
tions, press Reset button until the appli-
ance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Set the programme. The related pro-
gramme number flashes in the display.
4. Close the appliance door. The pro-
gramme starts.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button again and
again until the display shows the delay
56 www.electrolux.com