Myron&Davis NV8ACC1 - Manual (Page 9)

Step 4: Prepare vehicle
harnesses
Step 1 - Remove 4 screws from
OEM LCD Display
Step 2 - Remove OEM LCD
Display
Step 3- cont’d Step 4 - Secure OEM LCD
display with 4 screws
Step 5 - Arrange wiring
7 - Connecting and installing the Myron & Davis unit
Follow the steps below to ensure proper installation and connection of the Myron & Davis
unit.
Note: To ensure that the video cannot be viewed when the vehicle is in motion,
connect the (blue/white) Brake Wire to the Emergency Brake Switch
(grounded when engaged) .
Note: Carefully route the wire harnesses so they cannot be damaged during the
installation process of the Myron and Davis unit.
Step 3 - Install OEM LCD
display into trim panel