Asus SABERTOOTH Z77 - Manual (Page 41)

ASUS SABERTOOTH Z77 2-21
Chapter 2
• You can connect the front panel USB cable to the ASUS Q-Connector (USB, blue)
first, and then install the Q-Connector (USB) to the USB connector onboard if your
chassis supports front panel USB ports.
• Remove the USB dust cover before installation.
• The USB 2.0 connector module is purchased separately.
Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!
6. USB 2.0 connectors (10-1 pin USB78, USB56, USB910)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
7. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port(s).
Connect the S/PDIF Out module cable to this connector, then install the module to a
slot opening at the back of the system chassis.
The S/PDIF module is purchased separately.