Audio-Technica AT-LP60-USB - Manual (Page 4)

Initial Setup
4
Assembling the Turntable
The AT-LP60-USB requires some assembly before first use.
IMPORTANT: Do not connect the AC power cord until assembly is
complete.
1. Carefully place the turntable platter on the center spindle,
making certain the platter is fully seated on the spindle.
2. While holding both ends of the red tape ribbon on the
turntable belt, carefully pull the belt over the motor pulley (Fig.
2a). (If the belt drops off, remove the turntable platter and put
the belt back on it, as described on page 7.)
3. Once the belt is seated in the pulley’s groove, carefully
remove the ribbon. Make certain the belt is not twisted.
4. Place the turntable mat on top of the turntable platter
(Fig. 2b).
5. If desired, the hinged dust cover may be removed. Hold both
sides of the dust cover and pull upward gently and evenly to
detach the cover from the turntable (Fig. 2c). Keep the cover
in a safe, clean place.
6. To re-install the dust cover, guide the dust cover hinges into
the two hinge receptacles located at the back of the turntable
housing
Connecting to Computers with USB Input
The USB cable (included) connects your AT-LP60-USB turntable to your
computer without need for special drivers. Refer to included software
guide (also available online at www.audio-technica.com) before
connecting the turntable to your computer.
Setting the Pre-amp (Phono/Line) Switch
For increased flexibility of use, this turntable has an internal stereo
phono pre-amplifier. The Pre-amp Selector (Phono/Line) Switch is
located on the back of the turntable. If the stereo system you are using
has a PHONO input, set the Pre-amp Selector Switch to the “PHONO”
position. If your stereo system does not have a PHONO input, set
the Pre-amp Selector Switch to the “LINE” position and connect the
turntable’s output cables to the AUX or other high-level input on your
stereo system (described later) (Fig. 3).
NOTE: If you are using the USB cable to connect your turntable to a
computer, the Pre-amp Selector Switch setting has no effect on USB
operation.
2b – Record mat
2c – Dust cover removal
Figure 2 – Assembling the Turntable
Red ribbon Motor spindle
Drive belt
“AUX” PHONO
Stereo System
PHONO LINE USB
Input
Jacks
Pre-amp
Selector
Switch
White
Red
AC
AC
Figure 3
2a – Drive belt