Unpacking and removing shipping bolts, Warning – LG WM3001HRA User Manual

Page 11

Advertising
background image

I N S TA L L AT I O N I N S T RU C T I O N S

When removing the washer from the carton base, be

sure to remove the foam tub support in the middle of the

carton base.
If you must lay the washer down to remove the base

packaging materials, always lay it carefully on its side. Do

NOT lay the washer on its front or back.
IMPORTANT: To prevent internal damage during transport,

the washer is equipped with 4 shipping bolts and plastic

retainers. These bolts and retainers

MUST be removed

before operating the washer.
• Failure to remove shipping bolts and retainers may cause

severe vibration and noise, which can lead to permanent

damage to the washer. The cord is secured to the back of

the washer with a shipping bolt to help prevent operation

with shipping bolts in place.

Remove the retainers by turning them slightly

while pulling. Rotate and press the hole caps

into the shipping bolt holes.

Starting with the bottom 2 shipping bolts,

use the included wrench to remove the

4 shipping bolts by turning them

counterclockwise.

1

Shipping

Bolts

2

NOTE: Save the bolts and retainers for

future use. To prevent damage to internal

components, the shipping bolts and

retainers must be installed when

transporting the washer.

Retainer

Hole Cap

Carton Base

Foam Tub

Support

UNPACkINg AND REmOVINg SHIPPINg BOLTS

Removing the Protective Film

The front of the washer are covered with a protective

vinyl film. This film is to protect the finish during

shipping, and should be removed before use.

w

WARNINg

To reduce the risk of injury to persons when using this cleaner,
follow basic To reduce the risk of fire when using and install this
appliance
follow basic precautions, including the following :
• Do not install nearby heat item. Such as stove, cooking oven.

Failure to do so can cause deform, smoke and fire.

• Do not place candle and cigarettes on top of the product.

Failure to do so can cause deform, smoke and fire.

• Remove all protective vinyl film from the product.

Failure to do so can cause deform, smoke and fire.

11

Advertising