LG LSC27910SB - Manual (Page 19)

CARE AND CLEANING
6. Take out all removable parts, wrap them well and
tape together so they don’t shift and rattle during the
move. Refer to sections in Using your Refrigerator for
removal instructions.
7. Depending on the model, raise the front of the
refrigerator so it rolls more easily OR screw in the
leveling legs all the way so they don’t scrape the
floor. See the DOOR ALIGNMENT section.
8. Tape the doors shut and tape the power cord to the
refrigerator cabinet.
When you get to your new home, put everything back
and refer to the REFRIGERATION INSTALLATION
section for setup instructions.
OPERATION INSTRUCTIONS
A newly-installed refrigerator may take
12 to 24 hours to begin making ice.
The icemaker will produce 8 cubes per cycle,
approximately 120-150 cubes in a 24-hour period,
depending on freezer compartment temperature,
room temperature, number of door openings and other
If the refrigerator is used before the water connection is
made to the icemaker, set the power switch to O (Off).
When the refrigerator has been connected to the water
supply, set the power switch to I (On).
The icemaker will fill with water when it cools to freezing.
A newly-installed refrigerator may take 12 to 24 hours to
begin making ice cubes.
Throw away the first few batches of ice to allow the
water line to clear.
Personal Injury Hazard
Avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases
the cubes. DO NOTplace fingers or hands on the
automatic icemaking mechanism while the refrigerator
is plugged in.
WARNING
operating conditions.
arm.
Be sure nothing interferes with the sweep of the feeler
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
It is normal for several cubes to be stuck together .
If ice is not used frequently, old ice cubes will become
cloudy, taste stale, and shrink.
NOTE: If the cube size is smaller or larger than you
expected, you can regulate the size with the cube size
button.
Every time you press the cube size button, the indicator
moves up one light. The higher the light position the
larger cubes will be. Pressing at highest position returns
WHEN YOU SHOULD SET THE ICEMAKER
POWER SWITCH TO O (OFF)
When the water supply will be shut off for several
When the ice storage bin is removed for more than a
minute or two.
When the refrigerator will not be used for several
NORMAL SOUNDS YOU MAY HEAR
The icemaker water valve will buzz as the icemaker
fills with water. If the power switch is in the I (On)
position, it will buzz even if it has not yet been hooked
up to water. To stop the buzzing, move the power
NOTE: Keeping the power switch in the I (On) position
before the water line is connected can damage the
icemaker.
You will hear the sound of cubes dropping into the bin
and water running in the pipes as the icemaker refills.
Indicator to lowest position.
hours.
days.
switch to O (Off) position.
19
Indicator Light
Power
Switch
Water Amount
Selection Button
Feeler Arm