LG LS855 - Manual (Page 179)

Tools and Calendar 169
 Scan for devices: If the Bluetooth-compatible device (such as headsets, device,
printer, or computer) you want to pair with isn't on the list, make sure the target
device is set to be discoverable, then tap Scan for devices to scan again.
Pairing Bluetooth Devices
Paired Devices
The Bluetooth pairing process allows you to establish trusted connections between your device
and another Bluetooth device. When you pair devices, they share a passkey, allowing for fast,
secure connections while bypassing the discovery and authentication process.
To pair your phone with another Bluetooth device:
1. Verify your Bluetooth is active.
2. From the Bluetooth settings page, tap Discoverable to place a checkmark and make
your device visible. Your device must be visible to successfully pair with an external
device.
3. Tap Scan for devices. (Your device will display a list of discovered in-range Bluetooth
devices.)
4. Tap a device from the list to initiate pairing.
5. Depending on the device, you might have to tap Pair to accept the passkey (if they match
on both devices) , confirm matching passkeys, or enter the passkey or PIN Code.
6. Tap Done > OK if you entered a passkey or PIN code or passkey.
7. The external device will then have to accept the connection and enter your device‘s PIN
code.
 Once successfully paired to an external device, appears within the Status Bar.
Note: Due to different specifications and features of other Bluetooth-compatible devices,
display and operations may be different, and functions such as transfer or exchange
may not be possible with all Bluetooth compatible devices.
Pairing between two Bluetooth devices is a one-time process. Once a pairing has been
created, the devices will continue to recognize their partnership and exchange
information without having to re-enter a passcode again.
To disconnect a paired device:
Disconnecting a paired device breaks the connection between the device and your
LG Mar
quee™, but retains the pairing. At a later point when you wish to reconnect the device,
there is no need to setup the connection information again.