LG 37LD325H - Manual (Page 150)

33 206-4163
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 001). See Installer Menu detailed descriptions for further information.
TV Connections
Make these connections ONLY after Commercial Mode Setup and Cloning Master TV
procedures are complete.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
INTERFACE port on the TV’s jack panel. Then, connect HDMI, RGB, and Composite Video/Audio con-
nectors, as applicable, for the cable bundle.
Remote Jack Pack / TV Connections & Setup
093 RJP AVAILABLE 001
UPDATE RESET
AUDIO IN
(RGB/DVI)
RS-232C IN
(SERVICE ONLY)
. . . . .
. . . .
.......... 2
1
HDMI
/DVI IN
RJP
VIDEO L/MONO -AUDIO- R
AV IN 1
RGB IN (PC)
. . . . .
. . . . .
. . . . .
TV-LINK
CFG
GAME
CONTROL ..........
REMOTE
CONTROL
OUT
SPEAKER
OUT 8
HDMI
COMPONENT IN
R L P B Y P R
VIDEO AUDIO
( )
ANTENNA IN
HDMI/DVI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP
Connect RJ-45 Control cable
from RJP cable bundle.
RGB IN (PC)
Connect RGB connector from RJP
cable bundle (legacy RJP only).
AUDIO/VIDEO IN 1
Connect Composite Video/
Audio connectors from RJP
cable bundle. (Composite
Video on legacy RJP only.)
(26LD320H only)
(26LD320H only:
GAME CONTROL/MPI)