Electrolux QR2520X - Manual (Page 17)

1
3 4
2
• Unscrew the hinge (1) and remove the
cover plate (2) and the support (3).
• Remove the cover (4) on the opposite
side and install the support (3) the cov-
er plate (2) and the hinge (1). Install
the cover (4) on the opposite side.
1
2
3
• Unscrew the lower hinge (1). Move the
pin to the opposite side (2).
• Unscrew and move the pedal to the
opposite side (3).
• Screw on the lower hinge on the op-
posite side.
• Tighten the pin with the adjustment
spanner supplied.
• Use a small screw driver to remove the
bushing on the top of the door and
move it to the opposite side on the
door.
• Install the handle on the opposite
side.
• Raise the appliance and install the
ventilation grille.
• Put the cabinet in position.
WARNING!
Reposition, level the appliance,
wait for at least four hours and
then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cab-
inet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
8. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
ENGLISH
17