LG 60PY3DF-UJ - Manual (Page 15)

PREP
AR
ATION
13
NOT USING THE DESK-TYPE STAND
(For Plasma TV)
When not using the desk-type stand, install the sup-
plied desk-type stand fixture protection rubber caps
as shown at the figure.
To prevent the foreign materials from entering the
desk-type stand fixture, fix the desk-type stand fixture
protection cover(additional cover) by using the sup-
plied bolts as shown at the figure.
ADDITIONAL COVER
BOLT
RUBBER
■
It is applied to when installing only the 60PY3D/F model as wall-type.
n It is applied to when installing only the 50/60PY3D, 50/60PY3DF model as wall-type.
After installing the TV, you can adjust the the TV set manually to the left or right direction by 20 degrees to
suit your viewing position.
NOTE !
G G Before adjusting the angle, you must remove
the cable management and loosen (to the
left) the shaft bolt on the middle of stand’s
back. And when stand be level with TV, you
must close (to the right) the shaft bolt to
set the hole.
SWIVEL STAND
(For Plasma TV)