LG LSW600B - Manual (Page 6)

6
→ When installing the product on a masonry wall, turn the 8 screws on the A part counterclockwise to separate the
screw and bracket.
→ After aligning the wall bracket to the location to install, mark the part to screw on the wall and then remove the
wall bracket.
→ Refer to page 4 to attach the wall bracket.
→ Use a level to check whether the wall mount is level.
→ If the screw cannot be assembled in the designated location inevitably, it can be assembled by rearranging to the
closest location. But, do not change 2 or more locations from the designated spot.
→ Fix the right and left side with two bolts each.
→ Wall mounting equipment will be set up based in VESA 600X400 regulation.
→ At this time, use a "+" driver (Manual or motorized) or 8mm wrench to tighten the screw so that the wall, wall
bracket and screw are completely pressed against one another.
Separate the wall mount screw.
b.
c.
d.
e.
f.
→
→
3 How to install the wall mount
<When installing on a masonry wall>
→ When you separate the 8 screws on the wall mount connected to the wall bracket for use with a wooden wall,
it is much easier to install the product.
<
A