LG 60LB7100 - Manual (Page 31)

ENG
ENGLISH
31
MAGIC REMOTE FUNCTIONS
MAGIC REMOTE FUNCTIONS
When the message Magic remote control battery is low. Change the battery . is
displayed, replace the battery. To install batteries, open the battery cover, replace
batteries (1.5 V AA) matching and ends to the label inside the compartment,
and close the battery cover. Failure to match the correct polarities of the battery
may cause the battery to burst or leak, resulting in fire, personal injury, or ambient
pollution. Be sure to point the remote control at the remote control sensor on the
TV. To remove the batteries, perform the installation actions in reverse.
y Do not mix old and new batteries, as this may damage the remote control.
CAUTION
This remote uses infrared light. When in use, it should be pointed in the direction of the TV’s remote
sensor.
(POWER)
Turns the TV on or off.
Navigation buttons
(up/down/left/right)
Press the up, down, left or right button
to scroll the menu.
If you press
buttons while
the pointer is in use, the pointer will
disappear from the screen and Magic
Remote will operate like a general
remote control.
To display the pointer on the screen
again, shake Magic Remote to the left
and right.
(Home)
Accesses the Home menu.
(BACK)
Returns to the previous screen.
(EXIT to LIVE)
Switches among broadcast (antenna) and
various inputs.
Wheel (OK)
Press the center of the Wheel button
to select a menu.
You can change channels and scroll
the menu by using the Wheel
button.
VOL
Adjusts the volume level.
/INPUT
Displays the Screen Remote.
* Accesses the Universal Control Menu in
some regions.
* Pressing and holding the button will
display a menu to select an external device
that is connected to the TV.
Used for viewing 3D video.
(For 3D models)
(MUTE)
Mutes all sounds.
* By pressing and holding the button,
VD function will be enabled.
SAP(Secondary Audio Program) Feature can
also be enabled by pressing the key.
.
CH
Scrolls through the saved channels.
/INPUT
P
VOL CH
(Voice recognition)
Network connection is required to use
the voice recognition function.
1. Press the voice recognition button.
2. Speak when the voice display
window appears on the left of the TV
screen.
* Use the Magic Remote no further
than 10 cm (4 inch) from your face.
* The voice recognition may fail when
you speak too fast or too slowly.
* The recognition rate may vary
depending upon the user’s
characteristics (voice, pronunciation,
intonation, and speed) and the
environment (noise and TV volume).
Color buttons
These access special functions in
some menus.
( : Red, : Green, : Yellow,
: Blue)