LG LSW100BG - Manual (Page 6)

6
Safety pin
406mm
drywall
→ After mounting the display, insert the safety pin as
shown. If the safety pin is not fixated as shown in
the picture, the display can fall.
→ After the install is finished, pull the bottom part of
the display to verify the product is attached
securely.
→ In using cables or accessories not provided with
the wall mount, make sure to keep a certain
distance from the wall so that excessive force is
not applied on cables or accessories.
6
If the product is not leveled after the
installation, you can rotate the display
up to 5 degrees.
± 5°
± 5°
7
76mm
drywall
wood stud
<When mounting to wooden studs>
a. Locate and mark the centers of the wall studs using a stud finder.
b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and
then remove the wall bracket.
c. Use a level to make sure your screw marks are level.
d. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above where the wall mount screw location is marked
on the wall.
e. Clean the drilled hole.
f. Tighten the wall mount screws for the wall bracket on the drilled hole.
→ At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another.
(Drywall can be damaged when tightened with excessive force, please be careful.)
→ When tightening the screw use the "+" driver (Manual or motorized) or 8mm wrench.
5 How to assemble the wall mount support and display
- Always install the display with 2 or more people.
How to level the Display Cable arrangement and set protection cushion
- Arrange the cables as shown in the picture. Use some type of cable banding
device to hold all the cables together. Attach the set protection cushion to
mitigate the impact between the wall and the set when adjusting the angle.
Attach the set protection cushion as shown in the picture.