LG NB5541 - Manual (Page 20)

Operating 20
Oper
ating
3
AUTO POWER On/Off
This function automatically turns on/off the unit
when you turn on/off the TV or the external device
(DVD Player, Blu-ray Disc Player, etc.) connected to
this unit.
It is supported only on OPTICAL and LG TV
functions.
This function turns on or off each time you press
AUTO POWER.
y After the unit is turned on by AUTO POWER
function, it will be automatically turned off if
there is no signal for a certain period of time
from the TV connected by LG Sound Sync
(Optical/Wireless).
y After the unit is turned on by AUTO POWER
function, it will be automatically turned off if
there is no signal for a certain period of time
from the external device connected by an
optical cable.
y If you turned off the unit directly, it cannot
be turned on automatically by AUTO POWER
function. However the unit can be turned
on by AUTO POWER function when optical
signal comes in after 5 seconds of no signal.
y Depending on the connected device, this
function may not operate.
y In Bluetooth mode, this unit may be turned
on by AUTO POWER setting depending on
the connected Bluetooth device and then
LG TV function is selected.
In this case the unit will be turned off
automatically and when you restart the unit,
it will be turned on by LG TV function.
y If you want to use AUTO POWER, SIMPLINK
must be turned off. It takes for about 30
seconds to switch on or off SIMPLINK.
y AUTO POWER function does not operate
when this unit is connected with TV through
HDMI OUT jack because SIMPLINK signal
takes priority over AUTO POWER function.
,
Note
Auto power down
This unit will be off itself to save electric
consumption in the case main unit is not
connected to external device and is not used for 20
minutes.
So does this unit after six hours since Main unit
has been connected to other device using analog
input.
Sleep timer setting
Press SLEEP repeatedly to select the desired time
period options (in minutes):
DISPLAY OFF (display window will turns off ) ->
DIMMER (display window will be darkened by half )
-> Sleep timer value -> Display on
To check the remaining time, press SLEEP.
To cancel the sleep function, press SLEEP
repeatedly until “10MIN” appears, and then press
SLEEP once again while “10MIN” is displayed.
You can check the remaining time before the
unit turns off . Press SLEEP the remaining time
appears in the display window.
,
Note
NB5540-NE_DUSALLB_ENG.indd 20 2014-03-25 9:14:11