LG LFC20760SB - Manual (Page 19)

18
USING YOUR REFRIGERATOR USING YOUR REFRIGERATOR
Sliding Shelves (in some models)
You can slide some of the shelves in your refrigerator
towards inside or outside like explained below.
• To slide the shelf towards the outside: Pull towards you,
figure A.
• To slide the shelf towards the inside: Push until it stops,
figure B.
Figure A Figure B
In order to remove a shelf from a metal frame
• Pull the shelf until it stops.
• Incline the front of the shelf towards the top and pull
forward.
• Lift the shelf in the manner it moves across the
support openings.
To put back into place just reverse these steps.
Functional Shelves (Folding Shelves, in some models)
You can store tall articles like gallons or bottles just by
simply folding the shelf in half.
FROZEN MEAT COMPARTMENT/ CHEF FRESH
SNACK PAN (in some models)
To remove the Frozen Meat Compartment
• Pull the frozen meat compartment forward while
holding it with your other hand, slightly lift and pull.
• To replace the frozen meat compartment just follow
the steps in reverse.
On some models
applies an independent
temperature control
CRISPER HUMIDITY CONTROL (in some models)
For the conservation of fruits you can control and adjust
the humidity level (high or low) in the drawers.
• “High”: Allows air to leave the vegetable drawer for the
best conservation of fruits.
• “Low”: Allows air to be stored in the drawer for the best
conservation of vegetables.
CRISPER HUMIDITY CONTROL
You can adjust the humidity inside the drawers by
adjusting the control in a position between and .
For better preservation of the fruits allow air to leave
the vegetable drawer.
For a better conservation of vegetables allow the
maximum air in the drawer.
OPTIBIN CRISPERS
The OptiBin crisper maintains fruits and vegetables fresh
allowing you to easily control the humidity inside the
drawers. The Optibin crispers include 1) a front humidity
control and 2) a system that allows you to preserve or
avoid humidity.
Removing the glass
• Lift the opening of the drawers and use a flat head
screw driver (1).
• Pull towards the top and then out (2).
1
2
1
2