LG 32LH240H - Manual (Page 135)

P A G E 2 5 206-4118
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, use a paper clip or simi-
lar instrument inserted through the small hole marked ”RESET”
to activate the internal reset switch and restore normal opera-
tion. After a reset, check the real-time clock setting. It may be
necessary to reset the Clone Programmer clock from a TV con-
taining the correct time.
Note
The LT2002 programmer is designed to be used with TVs con-
taining the 221-01006 and later processors. Use with earlier TV
sets may give unpredictable results. Processors used before the
221-01006-04 have a limited screen display capability. They
cannot display entire screens as shown in the quick setup
instructions accompanying the LT2002 clone programmer. Use
the printed menu illustrations on the quick setup sheet sup-
plied with the Clone as an aid to making your programming
choices. (Although the menus are not all displayed, the clone
functions all operate normally.)
• After cloning operations are complete, just unplug the LT2002 from the TV.
• If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
Clone Programmer Troubleshooting
Problem Possible Cause(s) Possible Solution(s)
Clone Programmer
Clone copies Setup in
• Not enough time to copy - Press Reset on clone programmer, redo teach/learn.
less than 30 seconds entire TV setup. (Teach/Learn should take a minimum of 1 minute.)
Remote does not • Wrong Installer remote. - Only use an LG Installer remote to operate clone programmer
operate clone. with TV.
LED does not blink. • M.P.I. cord not connected. - Connect M.P.I. cord properly, assure good connection.
• TV not turned on. - TV must be powered On for clone to work.
• Weak batteries. - Install 4 fresh AA high-quality alkaline batteries.
Clone menu hard • Weak signal. - Connect TV to a reliable Analog channel signal
to read. source.
No time set. • Time not available. - Set time on a TV, copy time to Clone Programmer.
Clone not working. • Clone programmer - Try a different LT2002 Clone programmer.
problem. - Reset Clone Programmer.
Clone Scans Channels • Clone should only scan - Retry cloning again.
more than once. channels once.
Master and Other TVs
Cloning did not work.
• Procedure interrupted. - Wait until procedure complete message is displayed.
• Different TV models. - Cloning is only possible with identical model TVs.
• Step(s) omitted or - Reread pages 7-8-9 to be sure all tasks were performed.
not performed.
Clone time disappeared. • Batteries were removed. - Batteries must remain installed to retain time settings.
New Setup not present. • TV not reset. - Disconnect newly-cloned unit from power for 5 seconds.
Reference: LT2002 Cloning Procedure Troubleshooting
Warning: Do not use LT2002 while any PPV card is
installed in TV or clone programmer will be damaged.