LG GH22NP21 - Manual (Page 6)

3
Location and Function of Controls
❏ Occasionally CD-R and CD-RW discs written by a CD-R/RW drive cannot be read by other CD drives*.
These unreadable discs may need to be read using the CD-R/RW drive they were created with
* The disc written using the CD-R/RW drive might not be readable by CD-ROMs other than
Multi-read compatible (UDF compatible) CD-ROMs
Multiread compatible (UDF compatible) CD-ROMs are:
1. CD-ROMs that can read low reflectance. 2. CD-ROMs that support Packet Write.
❏ Please note: Certain software (i.e. particularly those including Video playback) may require a
considerably increased specification PC to give acceptable results. While this Super Multi DVD
Rewriter can read DVD-video discs, decoding them to display on your pc’s monitor requires
separate MPEG decoding that is done by separate hardware (either an MPEG decoder card or
MPEG decoding done by your video card), or separate software that you install to do MPEG
decoding. For further details, refer to the documentation that comes with MPEG software.
Front Panel
1. Jumper Connector
This jumper determines whether the drive is
configured as a master or slave. Changing the
master-slave configuration takes effect after
power-on reset.
2. IDE Interface Connector
Connect to the IDE (Integrated Device
Electronics) Interface using a 80-pin flat IDE
cable.
NOTE : Do not connect or disconnect the cable
when the power is on, as this could cause a
short circuit and damage the system.
Always turn the power OFF when connecting or
disconnecting this cable.
3. Power Connector
Rear Panel
1. Disc Tray
2. Emergency Eject Hole
3. Stop/Eject Button
4. Drive activity indicators
The LED is used to indicate the operation
of Super Multi DVD Rewriter .
1 2 3
4
1 2 3
This connector is not supported.