LG LGLS990 - Manual (Page 21)

Phone Basics 11
Once your phone is on, it may display “Searching for Service.” When your phone finds a signal, it enters
standby mode
– the phone‟s idle state. At this point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a Power Save feature is
automatically activated. When a signal is found, your phone automatically returns to standby mode.
In Power Save mode, your phone searches for a signal periodically without your intervention. You can
also initiate a search for Sprint service by pressing any key (when your phone is turned on).
Tip: The Power Save feature conserves your battery power when you are in an area where there is no
signal.
Turn Your Phone Off
1. Press and hold the Power/Lock Button for two seconds until you see the Phone options on
the display screen.
2. Tap Power off and then tap OK to power off the phone.
Your screen remains blank while your phone is off (unless the battery is charging).
Wake Up the Screen
If you don‟t use the phone for a while, the screen and backlight will shut off to conserve battery power.
1. Press the Power/Lock Button . Your lock screen will appear. See Lock Screen .
2. Swipe the screen to any direction to unlock it. The last screen you were working on opens. (This
is the default lock screen.)
Note: When turning the screen on, make sure you do not cover the proximity sensor. Doing so will not
allow you to turn the screen on.
Screen On/Off
The KnockON feature allows you to double-tap the screen to easily turn it on or off.
To Turn the Screen On
1. Double-tap the center of the Lock screen to turn the screen on.
2. Unlock the screen or access any of the available shortcuts or widgets.
To Turn the Screen Off
1. Double-tap an empty area of the Home screen or the Status Bar.
2. The screen will turn off.