LG 23ET63B-W - Manual (Page 8)

8
ENG
ENGLISH
ASSEMBLING AND PREPARING
3 Press the (Power) button on the front panel
to turn the power on.
Unplug the power cord before moving the
Monitor to another location. Otherwise electric
shock may occur.
CAUTION
Do not touch or press the screen when
adjusting the angle of the monitor.
WARNING
NOTE
To avoid injury to the fingers when adjusting
the screen, do not hold the upper part of the
stand as shown below.
Front Rear
y y Tilt from 15 to 58 degrees up or down to
adjust the angle of the Monitor set to suit
your view.
y y Avoid using the product in a high
temperature and high humidity area. Moving
the monitor from a environment like this to
an air conditioned area may cause moisture
formation inside the glass. This moisture
will be dissipate over time, which may vary
depending on the operating environment.
Using the Kensington security system
The Kensington security system connector is
located at the back of the Monitor set. For more
information of installation and using, refer to the
manual supplied with the Kensington security
system or visit
http://www.kensington.com.
Connect the Kensington security system cable
between the Monitor set and a table.
The Kensington security system is optional.
You can obtain it from most electronics stores.
NOTE
WARNING
Attach the rubber like the below picture.If not,
the fingers can be pinched or get damaged.