LG LDG3011ST - Manual (Page 30)

30 HOW TO USE
To set the SABBATH mode:
1 Press the A key.
2 Using the number keys, enter the desired temperature.
3 Press the q key.
4 Press and hold the X key for three seconds.
To change the temperature while in SABBATH mode
( no tones sound & no display change):
1 Press the upper or lower oven A key.
2 Using the number keys, set the desired temperature.
3 Press the q key.
SABBATH (Upper & Lower Oven)
The SABBATH mode is typically used on the Jewish Sabbath
and Holidays. When the SABBATH mode is activated, the
oven does not turn off until the SABBATH mode is deacti-
vated. In SABBATH mode, all function keys, except for the
and keys, are inactive. z will appear in oven
display.
NOTE
y IF the oven light is turned ON and the SABBATH mode
is active, the oven light will remain ON until the SAB-
BATH mode is turned OFF. If the oven light needs
to be OFF, be sure to turn the oven light OFF before
activating the SABBATH mode.
y SABBATH mode can only be used while baking (BAKE
mode) in either the top, bottom, or both ovens.
y You can use TIMED COOK in another oven while either
the upper oven or lower oven is activated.
Refer to “TIMED COOK” in the Using Oven section.
Upper oven only Lower oven only
Upper & Lower oven at the same time
D isplay Screen (example):
NOTE
y To cancel the BAKE function, press the or
key at any time.
y To cancel the SABBATH mode, press and hold the
X key for three seconds.
NOTE
y There is a 15 second delay before the unit will recog-
nize the temperature change.
For even and unhampered flame, the slits in the burner
heads must be kept clean at all times.The burner heads and
(the oval burner head) & Cap assembly can be lifted off.
y Wash the burner caps in hot soapy water and rinse
with clean water.
y Any spills on or around an electrode must be carefully
cleaned.
y To remove burnt-on food, soak the burner heads in
a solution of mild liquid detergent and hot water for
20–30 minutes. For stubborn stains, use a toothbrush.
y The burners will not operate properly if the burner ports
or electrodes are clogged or dirty.
y Burner caps and heads should be cleaned routinely,
especially after bad spillovers.
y Burners will not light if the cap is removed.