Avocent Network Device SPC420 - Manual (Page 135)

115
C H A P T E R
8
Adding and Deleting Units
This chapter describes how to add and delete units in the DSView 3 software.
Adding Units
You may add:
• A single managed appliance
• A single embedded appliance
• Multiple managed appliances based on a range of IP addresses
• A generic appliance or an EVR1500 environmental monitor
• A single target device that is not attached to a managed appliance
When a managed appliance is added, DSView 3 software administrator, user administrator and
appliance administrator privileges are automatically assigned to the managed appliance. A user
with any of these privileges may:
• Reboot a managed appliance and disconnect sessions
• Administer local user accounts on the managed appliance
• Control target device power
• Establish sessions with target devices from KVM switches, serial console appliances or other
supported units.
Appliance administrators and DSView 3 software administrators may also Flash upgrade a
managed appliance and configure settings for a managed appliance.
Managed appliance rights may be changed. See About Access Rights on page 144.
When you add a KVM switch or serial console appliance, attached target devices are also added.
If you add a KVM switch or serial console appliance that has an attached power device, the power
device is automatically added to the DSView 3 software database. Any target devices plugged into
the power device outlets (sockets) are also added, based on the options selected.
The applicable X.509 certificate is automatically copied from the DSView 3 software to the unit
being added. A certificate is a unique identifier of an individual managed appliance. (EVR1500