Ariens 911099 - LM21SH - Manual (Page 12)

GB - 12
Swivel Wheel Models (911101, 330,
525)
To change front wheel cutting height, insert
height adjuster pin into the holes that match
the desired cutting height and fasten with key
ring (Figure 7).
To change rear wheel cutting height, move
cutting height levers one notch at a time to
set the desired cutting height.
OPTIONAL CONTROLS
Primer Bulb (911330, 331, 514, 515,
525, 526, 531)
Push the primer bulb in to add fuel for easier
engine start.
Choke Control (911099, 101)
Move choke lever to the choke position to
start a cold engine.
Throttle (911102)
The throttle controls the
engine speed and chokes
engine for starting.
1.Start - Push lever all the way
forward.
2.Fast.
3.Slow - Pull lever all the way
rearward.
Throttle (911526)
The throttle controls the
engine speed and chokes
engine for starting.
1.Start - Push lever all the way
forward.
2.Fast.
3.Slow - Pull lever all the way
rearward.
Ignition Switch (911331, 515)
A removable key operates the
ignition switch. The key will
spring back to the “RUN”
position.
RUN Position (1): All controls
are operable.
START Position (2): Starter
turns over the engine.
Speed Control
Speed control rod changes the mower’s
forward travel speeds.
High –Push rod all the way
forward.
Low –Pull rod all the way
rearward.
Figure 7
1. Cutting Height Lever
2. Height Adjuster Pin
3. Key Ring
1
2
3
Rear
Front
High Low
OM1270
1
2
3
OL2074
1
2
3
OL2074
1
2
OM1000
OM0480