Salton, Inc AC8TC User Manual
Page 6
 
5
4. To prepare the Iron for steam,
Press the Reservoir down 3-4 
times to allow steam to flow 
through the Iron. The steam 
may not always be visible under 
normal conditions of use. If you
hear a hissing sound, steam is 
being released.
Caution: Do not leave the Iron near
plastic, easily melted or flammable
materials while the Barrel is hot.
USING THE IRON
Use only on dry hair.
For better curl control, it is
recommended to add a styling
mousse or styling spray to towel
dried hair. Thoroughly dry the hair
and proceed with curling.
1. Comb through hair and loosen 
any tangles.
2. Gather a section of hair
1 inch wide. Make sure that the 
section is not too thick or hair 
will not curl properly.
3. Press the Lever to raise the
Hair Clamp.
4. Insert the end of the hair under
the Hair Clamp on the side 
where the arrows are 
facing.(Diagram D)
5. Lower the Hair Clamp to secure
the hair against the Barrel.
6. Rotate the handle counter-
clockwise to wind the 
hair along the Barrel between 
the guides. It is easier if you 
support the Reservoir loosely 
with the other hand.
7. Press the Reservoir to make
steam. Thicker hair might need 
two or three presses.
8. Hold the curl in place for about
30 seconds (longer for thicker or
naturally curly hair).
9. Unwind carefully, raise the Hair
Clamp to release the hair, and 
let the curl cool.
CURLING TECHNIQUE
Before Curling:
Using sections is helpful when
curling hair.
1. Begin by sectioning off a "U" 
shape at the top crown of the 
head and clip.
Diagram D
AC8TC.qxd 6/3/2003 10:38 AM Page 5