Audiovox Rampage ACD83 - Manual (Page 11)

128-6003A
11 of 20
10 10 10 10 10
OPEROPEROPEROPEROPER
AAAAA
TTTTT
ING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUC
TTTTT
IONSIONSIONSIONSIONS
the D.UP button, and to return to a lower num-
ber disc, press the D.DN button. The number of
the disc in play will be shown on the display
panel.
cs
DISC EJECT ( )
Disc play is stopped and the disc is ejected
when the front panel is folded down and this
button on the rear of the panel is pressed.
Radio operation will automatically resume. If
the disc is not removed from the unit within
15 seconds of being ejected, it will
automatically be re-loaded into the unit to
prevent it from being accidentally damaged
(
will appear on the display panel to
indicate that a disc is loaded in the player).
Play of the disc can be resumed by using
the MODE button
bt
to choose the CD player
function. ct
TIME/FREQUENCY SELECTOR (T/F)
During radio, CD Player or optional CD
Changer operation, press this button to call
the time display on the incorporated quartz
clock. The current time will appear together
with an A or P indication. The display will
return to the radio frequency indication after
5 seconds.
cu
EQUALIZER BUTTON (EQ)
The EQ button applies preset sound effects
to the unit’s audio output signal.The EQ
button, when pressed, will activate one of
five operating modes (CLASSICS, POP,
JAZZ, DSP OFF or FLAT). Even though the
Equalizer function is active, as displayed
on the panel, if the bass and/or treble level
is set, the Equalizer function automatically
returns to the FLAT mode. Conversely, when
the Equalizer function is not active, the unit
returns to the user set bass and treble levels.
dl
THEFT-DETERRENT LED
Located on the chassis behind the front
panel, a light-emitting diode (LED) will flash
when the panel is physically removed. The
flashing light serves as a visual warning to
the would-be thief that the unit has been
disabled by removal of the front panel.
dm
RESET BUTTON
The RESET button is located above and to
the right of the theft deterrent LED. The reset
circuitry should only be activated under the
following circumstances as it will erase the
time and pre-set memories:
1.Upon initial installation after all wiring is
completed.
2.If there is a malfunction of any of the
switches on the unit, pressing the RESET
button may clear the system and return
to normal operation.
dn
FRONT PANEL RELEASE BUTTON
(OPEN)
This button is used to release the
mechanism that holds the front panel to the
chassis. To detach the front panel, press
the button so that the panel drops to the
lowered position. Grasp the panel at the
middle and pull it off of the chassis mounting
plate. To re-attach the panel, press it straight
onto the chassis mounting plate until the
mechanism locks it into place.
do
REMOTE SENSOR
The sensor to detect the infrared signal from
the wireless remote control is located behind
the VFD display lens. For optimum operation
of the remote control, always aim the control
at the VFD display.