Roominators ™ kit – Auralex Acoustics Roominators Performance Series User Manual

Page 2

Advertising
background image

D.

Mount the remaining panels on the ceiling,
focusing between the mix position and the

nearfield monitors. The graphic illustrates one

possible pattern for Studiofoam on the ceiling.

Other General Suggestions

When treating the front and side walls, try using a mirror to ascertain where

reflections are coming from. Simply have a friend move a mirror around the

walls and ceiling while you are sitting at the mix position. Anywhere you can see

your studio monitors in the reflection is a likely surface to treat with an Auralex

Studiofoam panel!

Do not worry about placing treatments very low on the walls—use them at ear

level and on the ceiling for best results. The number of panels and placement on

each surface can vary given your specific situation.

Remember that these are only guidelines. If you have furniture or gear in the way,

simply work around it as best you can. Auralex acoustic control products are very

forgiving. Placement on the walls is not an exact science. Just having LENRDs

and Studiofoam in the room will improve your mixing or recording environment. Other, less permanent methods, such as Velcro™,

nails, pins, screws, etc. can be used to mount the LENRDs or Studiofoam panels for easy removal later.

We highly recommend isolating your monitors with Auralex MoPADs. Even greater performance can be obtained by adding Auralex

diffusors or a GRAMMA amp/sub isolation riser.

This Starter Kit is designed to be the first step towards better acoustics. You may wish to continue to maximize your sound with products

such as our T’Fusor 3D Sound Diffusors or portable products such as our MAX-Wall™ Mobile Acoustical Environment.

Thank you for purchasing the Auralex Project

Roominators

™ Kit!

C.

Mount a total of 12 Studiofoam panels on the side walls - six
(6) on the left and six (6) on the right is encouraged, but

not mandatory. Around the mix position, you might want
to try using the “mirror” method to place panels (see
below). Note that in the illustration, two (2) panels
have been mounted to the door and can be seen
better in the illustration for step D.

Check out the Auralex Catalog or go to Auralex.com for details on all the great Auralex sound control products!

Advertising