HP 2600fx Optical Disk Drive - Manual (Page 17)

1-7
Setting the Operation Mode
The mode selection switch designates operating mode of the 2600fx:
• Select 0 to operate the optical disk drive as an optical memory device.
• Select 1 to operate the optical disk drive as a direct access device.
Hewlett-Packard recommends operating the optical disk drive as an optical
memory device. The direct access mode can be used with systems that do not
recognize optical memory devices.
To change the operation mode, push the appropriate button with a small
screwdriver or the point of a pen:
• the button above the operation mode window decreases the number by one
• the button below the operation mode window increases the number by one
Note
If you change the operation mode, you must power cycle the drive so that the host
recognizes the new mode.