Agilent Technologies HDMP-3001 - Manual (Page 6)

6
• Implemented in 0.25 micron
CMOS with 1.8 V core, 3.3 V I/O
power and LVCMOS
compatible I/Os.
• Provides a 16-bit general pur-
pose I/O (GPIO) register.
• Device power-up initialization
optionally through 2-wire
EEPROM interface.
• Configurable by hardware to
be connected to either a PHY
or a MAC from the system
connectivity viewpoint.
1.3 Applications
• Multi-Service Ethernet
Switches.
• Enhanced Services SONET/
SDH Add/Drop Multiplexers
(ADMs).
• DSU/CSUs.
1.4 Benefits
• Allows LANs to be intercon-
nected over leased OC-3c
lines, thereby extending a LAN
to multiple sites.
• Ethernet switches in each LAN
can be connected together di-
rectly which reduces cost and
complexity.
• Enables Transparent LAN
Services which, unlike POS
solutions, do not require
WAN access routers.
1.5 Interfaces
• System interface is a 25 MHz
IEEE 802.3 full-duplex, 100
Mb/s Ethernet MII port that
connects to either a PHY or a
MAC.
• Line side SERDES interface is
8-bit parallel data operating at
19.44 MHz. SONET/SDH
framer is compliant to
specifications ANSI T1.105 and
ITU G.707.
• Serial data channels for add
and drop of SONET overhead
bytes E1, E2, F1 and DCC.
• 8-bit microprocessor
interface allows direct
connection to the Motorola
MPC860.
AGILENT
FIBER OPTICS
SERDES
WITH CDR
AGILENT
HDMP-3001
SWITCH
FABRIC
MICROPROCESSOR
ETHERNET
PHYs
MDIO BUS
OC-3c PORT ETHERNET PORTS
PORT ON ETHERNET SWITCH
LINE CARD OF SONET ADM
ETHERNET
PHY
AGILENT
HDMP-3001
ADM EEPROM
SERDES
WITH CDR
AGILENT
FIBER OPTICS
DROP SIDE - 100 MBIT/S
FULL-DUPLEX ETHERNET
OC-48/12
SONET RING
MICROPROCESSOR
STAND ALONE DSU/CSU
ETHERNET
PHY
AGILENT
HDMP-3001
SONET SERDES
WITH CDR
AGILENT
FIBER OPTICS
100 MBIT/S
FULL-DUPLEX ETHERNET
OC-3c
Figure 2. HDMP-3001 Applications
• IEEE 802.3 MDIO management
interface.
• Standard 2-wire EEPROM
interface for optional boot-up
configuration.
• Provides 16-bit General
Purpose I/O (GPIO) register.
• Provides standard five-pin
IEEE 1149.1 JTAG test port.
1.6 Data Processing
• Complies to the GFP (Generic
Framing Procedure) draft
specification, revision 2, of
ANSI T1X1.5 and implements
both the null and linear header
options.
• Complies to the LAPS (Link
Access Procedure – SDH)
specification X.86 of ITU.
• Optional self-synchronous
X
43 +1 scrambling of the
payload.