HP ProBook 5320m Notebook PC - Manual (Page 136)

Select To do this
● Enable/disable Dual Core CPU (select models only;
enabled by default).
● Enable/Disable Unified Extensible Firmware Interface
(UEFI) mode (disabled by default).
● Turn the Numlock state at boot on or off.
Built-In Device Options ● Enable/disable the wireless button state (enabled by
default).
● Enable/disable the embedded WLAN device (enabled by
default).
● Enable/disable embedded WWAN device radio (select
models only; enabled by default).
● Enable/disable embedded Bluetooth® device radio
(enabled by default).
● Enable/disable the Network Interface Controller (LAN)
(enabled by default).
● Enable/disable LAN/WLAN switching (disabled by
default).
● Set the wake on LAN state. Options include the
following:
◦ Disabled
◦ Boot to Network (set by default)
◦ Follow Boot Order
● Enable/disable the fingerprint device (enabled by
default).
● Enable/disable a modem device (enabled by default).
● Enable the ambient light sensor (enabled by default).
● Enable/disable the Notebook Multibay device (enabled by
default).
● Enable/disable the integrated camera (select models
only; enabled by default).
● Enable/disable optical disk drive (enabled by default).
● Enable/disable internal microphones (enabled by
default).
Port Options (all are enabled by default) NOTE: All port options are enabled by default.
● Enable/disable the Smart Card slot.
● Enable/disable the ExpressCard slot.
● Enable/disable the serial port.
● Enable/disable the parallel port.
● Enable/disable the flash media reader.
126 Chapter 15 Computer Setup