3 modify system values, Preliminary steps, Modify passwords – ATTO Technology 1550D User Manual
Page 18: Set up a vlan: virtual local area network, Modify system values
13
ATTO Technology Inc. iPBridge Installation and Operation Manual
3.3 Modify System Values
Default values, even if you have not used the ExpressWizard, are appropriate for most configurations, but may
be modified.
Preliminary steps
1
If you are not already in the ExpressNAV
interface, type the IP address of your iPBridge
in a standard browser as found in
on page 25, click Enter Here,
type in your user name and password, and click
OK.
2
The Status page appears.
View the default settings by clicking on each
element in the left hand menu, then use the
individual pages listed on the side menu to
make changes or use other features.
Modify passwords
1
Follow the
2
Click Bridge.
The Bridge Configuration page is displayed.
The Administrator user name that you are
currently logged in with and the current read
only user name, if present, are displayed in
their text boxes.
3
Enter the Administrator (Admin) password
where indicated.
4
Enter appropriate information into the New
Admin Password, Confirm New Admin
Password or New Read Only Password and
Confirm New Read Only Password text
boxes.
5
Click Submit.
6
Go to the Restart page and restart the
iPBridge.
Set up a VLAN: Virtual Local Area Network
A Virtual LAN (VLAN) is a group of devices on the
same physical LAN which can communicate with each
other as if they were all on different physical LANs.
This creates a network that is independent of physical
location, allows grouping of users into logical
workgroups, increases efficient use of resources, and
adds security options by allowing some users into the
LAN and keeping other users out.
You may create up to eight Virtual LAN IDs for each
iSCSI data port. Each VLAN ID is assigned a VLAN
name of up to 64 characters. If no VLAN Id exists for a
data port, VLAN is disabled for that port.
1
Follow the
2
Click on the Ethernet menu item.
3
The Ethernet Port Configuration page
appears. Add a VLAN ID number and name in
the appropriate boxes.
4
Press Submit.
5
Go to the Restart page and restart the
iPBridge.
After rebooting, Virtual LAN takes effect.
Once VLAN has been enabled on a data port, some
features require a VLAN ID to be specified for that port:
SNTP (see Time & Date page), SNMP Traps (see
Remote Management page) and iSNS Server (see
iSCSI page).