Alpine CDA-7878R User Manual
Page 35
33
-EN
3WAY
F/R/Sub-W
Adjusting the Time Correction
9
Press the BAND button to select the channel to
be adjusted.
2 way system
3 way system
∗ Press the MODE button to switch to the Cut-off
frequency/Slope Adjusting mode.
10
Rotate the Audio Control knob to adjust the
value of the Time Correction (0.0 - 20.0).
11
To adjust another channel, repeat the steps 9 to 10.
12
When all the adjustments are completed, press
and hold the DIVIDER button for at least 2
seconds to cancel the Adjusting mode.
Storing the adjustments
You can store the adjustments.
13
Press and hold the MODE button for at least 2
seconds to store the settings (Or press the 1 or 2
button).
The display flashes.
14
While the display is flashing, press the 1 or 2
button.
The divider and the Time correction settings are
stored.
15
Press the DIVIDER button to return to normal
mode.
NOTES
• About the 2 way/3 way system
You can switch to 2way/3 way system mode with the 2
way/3 way switch on the side of the unit. (See on page
45)
When setting to “3 WAY”:
The unit can be operated in 3-way
system.
When setting to “F/R/Sub-W”:
The unit can be operated in 2-way
system.
• You cannot use the L.P.S. and Time Correction at the
same time.
Recalling the Stored Crossover/
Time Correction Settings
1
Press the DIVIDER button.
2
Press the g DN or f UP button to select
the stored content (Memory 1 or Memory 2).
Direct Recalling
Press the [1] or [2] button to recall the stored
adjustment.
3
Press the DIVIDER button to return to normal
mode.
NOTE
If you press the MODE button in step 2, the unit switches
to adjusting mode.
→
→
→
Low
range (L)
Low
range (R)
Front high
range (L)
←
←
←
Rear high
∗
range (R)
Rear high
range (L)
Front high
range (R)
→
→
→
Low range
(L)
Low range
(R)
Mid range
(L)
←
←
←
High
range∗
(R)
High
range (L)
Mid range
(R)