Ariens 911086 - LM21 - Manual (Page 15)

GB - 16
ENGINE/BLADE CONTROL
ADJUSTMENT
To adjust engine/blade control:
1. Loosen cable nuts away from bracket.
2. Squeeze z-bend bracket at engine end of
cable toward front of unit and hold in
place.
3. Pull cable down from bracket until there
is no slack in cable.
4. Tighten lower
cable nut to 1/8"
(3mm) below
bracket. Release
z-bend bracket.
5. Tighten upper
cable nut until
bracket is secure
between cable nuts.
6. Engage engine/blade control. Measure
distance between middle of z-bend and
cable bracket. Measurement should be
as shown below.
7. If correct measurement cannot be set,
contact your local dealer.
OM1010
Quantum
OM1040
No slack
OM1061
1/8”
(3mm)
OM1020
OM1030
1.325"-1.788"
(3.4cm - 4.5cm)
Quantum
OM1051