HP ProBook 5320m Notebook PC - Manual (Page 132)

Select To do this
● Enable/disable Display Diagnostic URL (enabled by
default).
● Enable/disable CD-ROM boot (enabled by default).
● Enable/disable SD Card boot (enabled by default).
● Enable/disable floppy boot (enabled by default).
● Enable/disable PXE Internal NIC boot (enabled by
default).
● Set the Express Boot Popup delay in seconds.
● Set the boot order.
Device Configurations ● Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the
following:
◦ Use of a USB keyboard in Computer Setup even
when a Windows® operating system is not running.
◦ Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
● Select a parallel port mode: ECP (Enhanced Capabilities
Port), standard, bidirectional, or EPP (Enhanced Parallel
Port).
● Enable/disable fan always on while connected to an AC
outlet (enabled by default).
● Enable/disable Data Execution Prevention. When
enabled, the processor can disable some virus code
execution, which helps to improve computer security.
● Enable/disable LAN Power Save (select models only).
When enabled, saves power by turning off the LAN when
not in use (enabled by default).
● SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
◦ AHCI (Advanced Host Controller Interface)
◦ IDE (Integrated Drive Electronics)
◦ RAID (select models only)
NOTE: Availability of the options above varies by
computer model.
● Enable/disable secondary battery fast charge (enabled by
default).
● Enable/disable HP QuickLook 3 (enabled by default).
● Enable/disable Virtualization Technology (select models
only; disabled by default).
● Enable/disable TXT (Intel® Trusted Execution
Technology) (select models only; disabled by default).
122 Chapter 15 Computer Setup