HP XP P9000 Command View Advanced Edition Software - Manual (Page 34)

You can also print information in topics by clicking the Print icon located in the top right of your Help
window.
Initial setup
After Replication Manager has been installed on a management server, you must configure initial
settings needed to begin Replication Manager operations.
Initial settings configuration workflow
The following figure shows the task flow of the initial configuration settings.
Setting up redundant pair management server configurations
Redundant pair management server configurations allow remote copy operations even when a remote
pair management server is unavailable (whether due to maintenance or hardware failure). Redundancy
can be defined in a variety of configurations, such as N:1 (N-to-one) and 1:M (one-to-many).
Pair management servers can be selected and registered (as a primary/secondary pair) during copy
group creation. Once registered, a pair of primary/secondary pair management servers is known
as a node. Nodes can be added or deleted as necessary without having to disband and reconstruct
the copy group.
This module includes the following topics:
• About redundant pair management server configurations , page 34
• Registering redundant pair management server nodes (while creating a copy group) , page 36
• Registering redundant pair management servers manually , page 37
• Adding pair management server nodes , page 37
• Deleting pair management server nodes , page 37
• Identifying a pair management server associated with a copy group , page 37
About redundant pair management server configurations
You can set up multiple pair management servers in any of four redundant configurations.
Getting started 34