HP Integrity NonStop H-Series - Manual (Page 41)

HP NonStop
RPM User’s Guide Page 41 of 52
5.7 SET Command
SET | S [ ALERTS ON|OFF ]
[ CRIT <percent-busy> ]
[ WARN <percent-busy> ]
[ INFO <percent-busy> ]
[ BUSY | % <value> ]
[ BUSYCPU <value> ]
[ BUSYPB <value> ]
[ ENTRIES <top-number> ]
[ LOGGING ON|OFF ]
[ LOGFILE <filename> ]
[ MAXINPUTS <value> ]
[ MAXIOS <value> ]
[ MAXOUTPUTS <value> ]
[ MAXRCVQ <value> ]
[ MAXSWAPS <value> ]
[ OBEYESCAPE ON|OFF ]
[ PAGECLEAR ON|OFF ]
[ SORT ByCpu | ByNode ]
[ TRACETOKEN ON|OFF ]
[ USECS ON|OFF ]
[ RATE <default-seconds> ]
[ TERM TTY | VT100 | T6530 ]
The S or SET command controls properties of the run-time environment.
ALERTS ON|OFF - reserved for future use.
CRIT <percent> value of Cpu Busy threshold for Critical alerts.
WARN <percent> value of Cpu Busy threshold for Warning alerts.
INFO <percent> value of Cpu Busy threshold for Info alerts.
BUSY | % | BUSYCPU | BUSYPB <percent> indicates the default busy threshold value.
If BUSY|% <percent> is specified then <percent> applies to both the CPU and PB
command. Specifying separate BUSYCPU <percent> or BUSYPB <percent> defines
the BUSY value for the CPU and/or PB commands respectively.