HP ProLiant BL25p Server-Blade - Manual (Page 18)

18 HP ProLiant BL25p Server Blade User Guide
For more information about iLO, refer to "Configuration and Utilities (on
page
45 )."
Power Down the Server Blade
Power down the server blade using either of the following methods:
•
•
Press the Power On/Standby button on the server blade front panel.
Be sure that the server blade is in standby mode by observing that the power
LED is amber. This process may take 30 seconds, during which time some
internal circuitry remains active.
Use the virtual power button feature in iLO.
After initiating a manual or virtual power down command, be sure that the
server blade goes into standby mode by observing that the power LED is
amber.
IMPORTANT: When the server blade is in standby mode, auxiliary
power is still being provided. To remove all power from the server blade,
remove the server blade from the server blade enclosure.
IMPORTANT: Remote power procedures require the most recent
firmware for the power enclosure and server blade enclosure
management modules. For the most recent firmware, refer to the HP
website (
http://www.hp.com/go/support ).
Remove the Server Blade
1. Identify the proper server blade in the server blade enclosure.
2. Back up all server blade data.
3. Power down the server blade (on page 18 ).