HP XP P9500 Storage - Manual (Page 32)

Table 12 Auto Migration General Status Messages (continued)
Description Message
This message is output when you start Auto LUN in the
following conditions: Auto migration is not available. All the parity groups cannot
be used for auto migration.
•
All volumes in the storage system are external volumes
•
All parity groups in the storage system have On-Demand
settings
An internal logic error occurred in the SVP. Contact the
service engineer for information on resolving this issue. An internal logic error occurred.
Successful auto migration plan messages
Table 13 (page 32) lists messages related to successful auto migration plans.
The LDKC:CU:LDEV and Group X-X variables in the Message column represent the LDEV ID and
the parity group.
Table 13 Successful Auto Migration Plan Messages
Description Message
The stated auto migration plan was created. ‘NNN’ represents
the number of the auto migration plan. The auto migration plan NNN was created. Source
= LDKC:CU:LDEV in Group X-X, Target =
LDKC:CU:LDEV in Group X-X.
The execution of the stated auto migration plan was completed
successfully. The first LDEV ID represents the source volume and
the second LDEV ID represents the target volume. The auto migration plan
(LDKC:CU:LDEV->LDKC:CU:LDEV) was executed
normally.
Auto LUN found a proper target volume candidate corresponding
to the specified source volume candidate. The source volume was
migrated to a parity group in a higher HDD class. Source candidate = LDKC:CU:LDEV in Group X-X
Target candidate = LDKC:CU:LDEV in Group X-X
Auto migration of a volume to a higher HDD class.
Auto LUN found a proper target volume candidate corresponding
to the specified source volume candidate. The source volume was
migrated to a parity group in a lower HDD class. Source candidate = LDKC:CU:LDEV in Group X-X
Target candidate = LDKC:CU:LDEV in Group X-X
Auto migration of a volume to a lower HDD class.
Auto LUN found a proper target volume candidate corresponding
to the specified source volume candidate. The source volume was
migrated to a parity group in the same HDD class. Source candidate = LDKC:CU:LDEV in Group X-X
Target candidate = LDKC:CU:LDEV in Group X-X
Auto migration of a volume in the same HDD class.
Stopped auto migration plan messages
Table 14 (page 32) lists messages related to auto migration plans that were stopped abnormally.
The LDKC:CU:LDEV IDs in the Message column represent the source volume and target volume,
respectively.
Table 14 Stopped Auto Migration Plan Messages
Description Message
The execution of the auto migration plan was stopped
because the specified target volume is not a reserved The auto migration plan (LDKC:CU:LDEV->LDKC:CU:LDEV)
was stopped. The specified target volume is not the
reserved volume.
volume. This volume was changed to a normal volume after
the creation of the auto migration plan.
The emulation type of the source volume is different from
that of the target volume. The volume configuration might The auto migration plan (LDKC:CU:LDEV->LDKC:CU:LDEV)
was stopped. There is an emulation type mismatch between
source and target volumes.
have been changed after the creation of the auto migration
plan.
32 Auto LUN monitoring