HP ProBook 455 G1 Notebook PC - Manual (Page 59)

Removing or replacing the service door
Removing the service door
Remove the service door to access the memory module slot, hard drive, and other components.
1. Remove the battery (see Inserting or removing the battery on page 40 ).
2. With the battery bay toward you, remove the security screw (1) (if the optional screw is being
used, see Using the optional security screw on page 48 ), and then slide the service door release
latches (2) to release the service door.
NOTE: You can slide the battery release latches simultaneously or you can slide them one at a
time.
3. Slide the service door towards the front of the computer (3) and lift (4) to remove the service
door.
Replacing the service door
Replace the service door after accessing the memory module slot, hard drive, regulatory label, and
other components.
1. Tilt the service door down to align the tabs on the service door with the latches on the computer
(1).
2. Insert the alignment tabs (2) on the rear edge of the service door with the notches on the
computer.
NOTE: The release latches automatically lock the service door into place (3).
Using hard drives 49