HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 6)

Introduction 6
• A VCSU update operation can be performed from a server blade in the same enclosure that is being
updated. However, this feature is supported only when using a redundant network configuration on the
server blade running the VCSU client.
• This version of VCSU supports c3000 and c7000 enclosures.
• VCSU does not update modules that are powered off, non-functional, or not physically present. A status
message indicates whether any modules are in these states.
• VCSU does not update unknown or unsupported module types, including pass-thru Ethernet and FC
modules.
• HTTP and HTTPS downloads are restricted to non-authenticated websites.
• FTP downloads are restricted to non-SSL/TLS, Passive Transfer Mode FTP sites.
• IP addresses that are not accessible time out within 20 seconds. IP addresses that have an active
SSL-enabled web server, but not an OA, fail immediately.
• Prior to running VCSU, ensure that the maximum supported number of local user accounts for the
Onboard Administrator has not been reached. For multi-enclosure domains, verify this information for
each enclosure in the domain.
• VCSU does not use any root certificates to connect to OA and VC.
• VCSU does not support updating the firmware using IPv6 Link Local Addresses on Linux or HP-UX.
• VCSU does not support the Windows 2008-based IIS FTP server for downloading the firmware.
Supported modules
Module Supported in
VCSU 1.9.1
HP 1/10Gb Virtual Connect Ethernet Module Yes*
HP 1/10Gb-F Virtual Connect Ethernet Module Yes*
HP Virtual Connect Flex-10 10Gb Ethernet Module
Yes
HP Virtual Connect FlexFabric 10Gb/24-port Module Yes
HP Virtual Connect Flex-10/10D Module Yes**
HP 4Gb Virtual Connect Fibre Channel Module Yes†
HP Virtual Connect 4Gb Fibre Channel Module Yes
HP Virtual Connect 8Gb 24-Port Fibre Channel Module Yes
HP Virtual Connect 8Gb 20-Port Fibre Channel Module Yes
* Supported only for updates to VC version 3.60 or lower. This module is not supported for updates to VC version 3.70
or higher.
** Supported only for updates to VC 3.70 or higher. This module is not supported for updates to VC version 3.60 or
lower.
† Supported only for updates to VC 4.01 or lower. This module is not supported for updates to VC version 4.10 or
higher.
Command line syntax
CLI input is case-insensitive except when otherwise noted. The general CLI syntax is as follows:
vcsu -a <command>
Parameters are extensions that provide extra information required for the execution of a particular command.
Whether or not a parameter is required depends on the specific action being executed.