HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 8)

Introduction 8
Interactive mode question/request Description Reference
module. If not specified, the default
is all supported modules.
resetvcm
update (on page
14 )
version
-b <BAY>
Please enter the file
location:
(optional) Full path to the
configuration backup or support
dump file
configbackup (on page
11 )
supportdump
-l <FILE>
Please enter the
Configuration backup
password:
(optional) Password for the
configuration backup file
configbackup (on page
11 )
update (on page 14 )
-cp <CONFIG PASS>
Do you want to force an
update on modules? (yes/no):
(optional) Enter Yes to force an
update on modules.
update (on page 14 )
-f <FORCE>
Please enter Force Update
options (eg:
version,health):
Required only if previous question
was answered yes. Enter options
separated by a comma.
update (on page 14 )
-f <FORCE>
Do you want to specify VC-
Enet module activation
order? (yes/no):
(optional) Specify VC-Enet module
activation order update (on page 14 )
-oe <ORDER>
Please enter VC-Enet module
activation order (eg:
parallel or odd-even or
serial or manual):
Required only if previous question
was answered yes. Enter one of the
following: parallel, odd-even, serial,
or manual
update (on page 14 )
-oe <ORDER>
Do you want to specify VC-FC
module activation order?
(yes/no):
(optional) Specify VC-FC module
activation order.
update (on page 14 )
-of <ORDER>
Please enter VC-FC module
activation odrer (eg:
parallel or odd-even or
serial or manual):
Required only if previous question
was answered yes. Enter one of the
following: parallel, odd-even, serial,
or manual
update (on page 14 )
-of <ORDER>